Electronic ballast 1 lamp fc8t9 t5 model hd22 120b 14 40 14 40.
1 lamp electronic ballast.
Optimized to provide the highest efficiency while operating tled lamps at their design wattage lumens.
Rapid start electronic ballasts start lamps quickly 0 5 1 0 seconds without flicker by heating the lamp electrodes and simultaneously applying a starting voltage.
Full rated light output ballast factor 1 0 extra energy savings compared to operating with standard centum and optimum ballasts.
Set your store to see local availability add to cart.
Ge ultrastart proline electronic ballast 120 277 volt program rapid start ballast normal ballast factor ballast for fluorescent light 1 or 2 lamp t12 4 6 out of 5 stars 75 17 83 17.
1 lamp rapid start ballast.
Filter results filter results normal ballast factor.
Ge lighting 96720 ge232 mvps l 120 277 volt ultrastart electronic fluorescent t8 programmed rapid start ballast 2 or 1 f32t8 lamps 4 7 out of 5 stars 74 8 18 8.
The starting voltage of about 500v for f32t8 systems is sufficient to start a discharge through the lamps when the electrodes have reached an adequate temperature.
Since ballasts are so important to the lifespan and health of your fluorescent lamps it.
1 lamp t8 electronic fluorescent ballasts.
Free delivery with 45 order.
The ballast blue wires connect to one end of the lamp the red wires connect to the other side.
Find ballasts at lowe s today.
Amax lighting 120 volt 4 13 in.
Damp location rated ballasts can be used in areas where moisture is present.
An electronic ballast uses solid state electronic circuitry to provide the proper starting and operating electrical conditions to power discharge lamps.
When replacing existing ballast due to age or mandate new drivers offer the highest efficiency opportunity.
These ballasts operate one t8 lamp measuring 2 3 or 4 feet in length.
Depending on your commercial or residential application your needs can differ quite a bit.
An electronic ballast can be smaller and lighter than a comparably rated magnetic one.
An electronic ballast is usually quieter than a magnetic one which produces a line frequency hum by vibration of the transformer laminations.
The common yellow wires are capped with small wire connectors.
After 1 lamp rapid start ballast is replaced with a 2 lamp rapid start ballast.
The right 1 lamp electronic ballast protects the light source from damage and helps maintain consistently high quality illumination throughout the life of the lamp.
Ballasts with an indoor location rating should be used in dry locations only.